Steps to  Set/Change IP in KDS as below:

  1. Reboot the Logic Controller by unplugging and replugging  the power cable.
  2. Immediately press the down arrow button(Blue button) 2-3 times on bump bar shown in the screenshot.

The Setting screen will open  on the KDS Monitor as below on the screenshot.

 

 

Under the MAIN tab.

Change the Station address to “2”. To navigate press the Down arrow(blue button) on the Bump bar and use the number Key to change the value.

Now;Navigate toEthernet Tab by pressing the -> arrow (Green button) on bump bar as highlighted   in the below screenshot.

 

Navigate by pressing the Down arrow(blue button) on the Bump bar and use the number Key to change the value.

Change the following fields

IP ADDRESS: 192.168.50.28
SUBNET MASK: 255.255.255.128

     Ethernet Tab  Screenshot .

Navigate to the SERIAL Tab as below on the screen shot and compare the Com1 port and Com2 portsettings with below screenshot.

Serial Tab Screen shot

 

Now go to Exit Tab and select Exit and Save and Press Enterbutton on bumpbar

As shown in below screenshot.

Save Button Screen shot

                                 Exit And Save. Screen shot